Endeavor V6-3.8L SOHC (2004)
NOTE: rear ABS rotors (FWD) are integrated with the rear hub assembly and cannot be disassembled.
REMOVAL SERVICE POINT
<<A>> FRONT ABS SENSOR/REAR ABS SENSOR REMOVAL
CAUTION: Be careful when handling the projection at the tip of the ABS sensor and the toothed edge of the ABS rotor so as not to damage them
by contacting other parts.
INSPECTION
ABS SENSOR CHECK
1. Check whether any metallic foreign material has adhered to the projection at the speed sensor tip. Remove any foreign material. Also check
whether the pole piece is damaged. Replace it with a new one if it is damaged.
NOTE: The projection can become magnetized due to the magnet inside the ABS sensor, causing foreign material to easily adhere to it. The
projection may not be able to correctly sense the wheel rotation speed if foreign matter is on it or if it is damaged.
2. Measure the resistance between the ABS sensor terminals.
Standard value: 1.24 - 1.64 kOhms
3. If the internal resistance of the ABS sensor is not within the standard value, replace it with a new ABS sensor.
4. Remove all connections from the ABS sensor. The circuit should be open between terminals (1) and (2) and the body of the ABS sensor. If the
circuit is not open, replace with a new ABS sensor.
5. Check the ABS sensor cable for breakage, damage or disconnection. Replace with a new one if a problem is found.
