Endeavor V6-3.8L SOHC (2004)
CAUTION: Do not wipe off the special grease that is on the lock pin or allow it to contaminate the lock pin.
2. Remove the lock pin bolt. Pivot the caliper assembly and hold it with wires.
3. Remove the following parts from caliper support.
1) Pad assembly
2) Pad and wear indicator assembly or Pad assembly
3) Shim
4) Clip
4. In order to measure the brake drag force after pad installation, measure the rotary-sliding resistance of the hub with the pads removed.
5. Install the pads and caliper assembly, and then check the brake drag force.
