Endeavor V6-3.8L SOHC (2004)
Lateral Accelerometer: Service and Repair
Anti-Lock Braking System (ABS)
G-SENSOR
REMOVAL AND INSTALLATION
CAUTION: Do not drop or apply a shock on the G-sensor.
INSTALLATION SERVICE POINT
>>A<< G-SENSOR INSTALLATION
The arrow mark on the G-sensor must point toward the rear of the vehicle.
INSPECTION
G-SENSOR CHECK
Required Special Tool:
^
MB991348: Test Harness Set
1. Disconnect the G-sensor connector and connect special tool MB991348, between the disconnected connectors.
2. With the ignition switch turned to the "ON" position, read the voltage between terminals number 2 and number 3.
Standard Value: 2.4 - 2.6 Volts
3. With special tool MB991348 connected, rotate so that the arrow points straight down. Read output voltage between terminals number 2 and
