Endeavor V6-3.8L SOHC (2004)
1. Remove the union joint and bolt from special tool MD998709 (adapter hose) and instead attach special tool MD998742 (hose adapter) to the
adapter hose.
2. Install special tool MB991637 (fuel pressure gauge set) into assembled special tools MD998709 and MD998742 via a gasket.
3. Install the assembled fuel pressure measurement tools between the fuel rail and fuel high-pressure hose.
CAUTION: To prevent damage to scan tool MB991958, always turn the ignition switch to the "LOCK" (OFF) position before connecting or
disconnecting scan tool MB991958.
4. Connect scan tool MB991958 to the data link connector.
5. Use Actuator test 07 to drive the fuel pump. Check that there is no fuel leaking from any section when the fuel pump is operating.
6. Stop the fuel pump.
7. Start the engine and run at idle.
8. Measure fuel pressure while the engine is running at idle.
Standard value: Approximately 324 kPa (95.7 in.Hg) at curb idle
9. Check to see that fuel pressure at idle does not drop even after the engine has been revved several times.
