Endeavor V6-3.8L SOHC (2004)
If a new compressor is installed, first adjust the amount of oil according to the procedures described below, and then install the compressor.
1. Measure the amount [X cu.cm (X fl.oz) of oil within the removed compressor.
2. Drain (from the new compressor) the amount of oil calculated according to the following formula, and then install the new compressor.
New compressor oil amount = 140 sq.cm (4.7 fl.oz)
140 cu.cm - X cu.cm = Y cu.cm (4.7 fl.oz. - X fl.oz. = Y fl.oz)
NOTE: Y cu.cm (Y fl.oz) indicates the amount of oil in the refrigerant line, the condenser, the evaporator, etc.
NOTE: When replacing the following parts at the same times as the compressor, subtract the rated oil amount of each part from Y cu.cm (Y fl.oz) and
discharge from the new compressor.
Quantity:
-
Evaporator: 60 cu.cm (2.0 fl.oz)
-
Condenser: 15 cu.cm (0.5 fl.oz)
-
Suction hose: 10 cu.cm (0.3 fl.oz)
-
Receiver: 10 cu.cm (0.3 fl.oz)
