Endeavor V6-3.8L SOHC (2004)
This is called "Timer function".
-
Sounds the tone alarm 12 cycles (after 0.5 seconds) if any of the following conditions is met when sixty seconds or more have elapsed since the
ignition switch is turned "ON". One cycle consists of five-second "on" and then three-second "off".
a. The vehicle speed has reached 8 km/h (5 mph) while the seat belt switch is turned on (driver's seat belt is not fastened) with the ignition switch
"ON."
b. The seat belt switch has been turned on (driver's seat belt has not been fastened) for at least ten seconds while the ignition switch has been
turned "ON" and the vehicle speed has been 8 km/h (5 mph) or more.
NOTE: Once the tone alarm has sounded 12 cycles, it does not sound again until the vehicle speed reduces to 3 km/h (2 mph) or less even if
any of the following conditions is met.
-
The tone alarm stops sounding if the ignition switch or the seat belt switch is turned off (the driver's seat belt is fastened) while the timer operation
is active.
Door ajar warning buzzer
The buzzer is sounded 4 times by the ETACS-ECU to warn the driver if any door (including the tailgate or glass hatch) is open when the ignition is
switched ON and the vehicle speed reaches 8 km/h or faster. The buzzer will continue to sound for 4 times even if the ignition, door status, or vehicle
speed requirements are not maintained.
NOTE: The warning buzzer can be customized on vehicles equipped with a multi-center display (middle grade type). Refer to Powertrain
Management/Computers and Control Systems/Information Bus/Service and Repair.
Center display operation tone <vehicles with multi-center display (middle-grade type)>
The ETACS-ECU sounds the buzzer when the buzzer signal is sent from the center display.
Turn-signal light buzzer
The ETACS-ECU sounds the buzzer in sync with the turn signal lights or hazard warning lights.
NOTE: The turn-signal light buzzer can be customized on vehicles equipped with a multi-center display (middle grade type). Refer to Powertrain
Management/Computers and Control Systems/Information Bus/Service and Repair.
