Endeavor V6-3.8L SOHC (2004)
NOTE: Also check joint connector (3) C-103 and junction block connector C-211 and C-215 for loose, corroded, or damaged terminals, or terminals
pushed back in the connector. If joint connector (3) C-103 or junction block connector C-211 or C-215 is damaged, repair or replace the wiring harness.
Refer to Harness Connector Inspection.
Q: Is the wiring harness between multi-center display unit (middle grade type) connector C-06 (terminal 2) and ignition switch (IG1) in good condition?
YES : Go to Step 13.
NO : Repair the wiring harness. The multi-center display unit (middle grade type) should work normally.
STEP 13. Check the multi-center display unit (middle grade type) power supply circuit [ignition switch (IG2)]. Measure the voltage at the
multi-center display unit (middle grade type) connector C-06.
1. Disconnect the multi-center display unit (middle grade type) connector C-06 and measure at the harness side.
2. Turn the ignition switch to "ON" position.
