Endeavor V6-3.8L SOHC (2004)
3. Measure the voltage between terminal 2 and ground.
-
The measured value should be approximately 12 volts (battery positive voltage).
Q: Does the measured voltage correspond with this range?
YES : Replace the multi-center display unit (middle grade type). The multi-center display unit (middle grade type) should work normally.
NO : Go to Step 11.
STEP 11. Check the multi-center display unit (middle grade type) connector C-06 for loose, corroded or damaged terminals, or terminals
pushed back in the connector.
Q: Is multi-center display unit (middle grade type) connector C-06 in good condition?
YES : Go to Step 12.
NO : Repair or replace the connector. Refer to Harness Connector Inspection. The multi-center display unit (middle grade type) should work
normally.
STEP 12. Check the wiring harness between multi-center display unit (middle grade type) connector C-06 (terminal 2) and ignition switch
(IG1).
