Endeavor V6-3.8L SOHC (2004)
1. Place on tire changing machine and break both tire beads ensuring that the transmitter remains in the bottom of the tire.
CAUTION: Be careful not to damage the TPMS transmitter.
2. Lubricate tire well and remove outer side of the tire.
3. Reach inside the tire and remove the TPMS transmitter.
4. Remove tire from rim using proper tire changing equipment procedures.
<<C>> GROMMET REMOVAL
CAUTION: Use a soft tool to remove the grommet to prevent scratching the valve of the TPMS transmitter.
Remove the grommet from the TPMS transmitter.
INSTALLATION SERVICE POINTS
>>A<< GROMMET/TPMS TRANSMITTER/VALVE NUT INSTALLATION
1. Slide inner tire bead over rim face. Use lubricant, as normal procedures require.
2. Install a new grommet to the TPMS transmitter.
CAUTION:
^
Visually check that TPMS transmitter is not deformed or damaged.
^
When installing the TPMS transmitter, be sure the rim, grommet and valve nut are clean.
^
Ensure the grommet is located inside the valve hole before installing the valve nut.
^
While installing the valve nut, hold the valve and grommet firmly in contact with the rim.
^
While installing the valve nut, ensure the tool is kept aligned to the valve and the valve hole.
^
After installing the valve nut, check that the grommet is compressed.
