Endeavor V6-3.8L SOHC (2004)
Tire Pressure Sensor: Testing and Inspection
Tire Pressure Sensor Check
TIRE PRESSURE SENSOR CHECK
Required Special Tools:
^
MIT46716: TPMS Magnet
^
MB991958: Scan Tool (MUT-III Sub Assembly)
^
MB991824: Vehicle Communication Interface (V.C.I.)
^
MB991827: MUT-III USB Cable
^
MB991910: MUT-III Main Harness
A Check the condition of the tire pressure sensor as described.
CAUTION: To prevent damage to scan tool MB991958, always turn the ignition switch to the "LOCK" (OFF) position before connecting or
disconnecting scan tool MB991958.
1. Connect scan tool MB991958 to the data link connector.
2. Turn the ignition switch to the "ON" position.
3. Select "Interactive Diagnosis" from the start-up screen.
4. Select "System select."
5. Choose "TPMS" from the "CHASSIS" tab.
6. Select "MITSUBISHI."
7. Select"Special Function."
8. Select "Tire Pressure Sensor Check."
9. Send the signal from an intended transmitter as follows:
1) Clean the TPMS transmitter location on the wheel rim.
2) Position MIT46716 or a strong magnet as shown, and hold it there for 5 seconds or more.
NOTE: By doing this work, the reed switch (incorporated in the TPMS transmitter) will activate the TPMS transmitter to send the pressure
sensor data.
