Endeavor V6-3.8L SOHC (2004)
Fuel Pressure Release: Service and Repair
FUEL PUMP CONNECTOR DISCONNECTION (HOW TO REDUCE PRESSURIZED FUEL LINES)
WARNING: When removing the fuel pipe, etc., release fuel pressure to prevent fuel spray.
1. Remove the left rear seat cushion mounting bolts, and lift the left rear seat cushion to tie it to the head restraint.
2. Cut the floor mat and then remove the service hole cover to gain access to the service hole.
NOTE: Push the floor mat to find the notches and cut the floor mat along them.
3. Disconnect the fuel pump module connector.
4. After starting the engine and letting it run until it stops naturally, turn the ignition switch to the "LOCK" (OFF) position.
5. Connect the fuel pump module connector.
6. Install the service hole cover.
