Endeavor V6-3.8L SOHC (2004)
CAUTION: Poor idling etc. may result if the throttle body gasket is installed incorrectly.
Align the recess on the intake manifold plenum with the projection of the throttle body gasket, and then install the gasket.
The ETV must be initialized after performing any of the following operations:
^
Throttle body installation, removal, or replacement
^
Throttle body cleaning
^
PCM removal, installation, or replacement
^
Battery cable disconnect and reconnect
^
PCM reprogramming
To initialize the ETV, turn the ignition switch to the ON position (do not start engine), then turn it off. Keep it off for at least 10 seconds before starting
the engine.
