Endeavor V6-3.8L SOHC (2004)
6.
Gather the following reprogramming equipment:
-
MUT-III/STV Reflash Update CD 3/05 or later
-
Memory Card 128 MByte Compact Flash MB991853
-
Memory Card Adapter PCMCIA MB991939
-
"Engine Compartment/Control Module" Labels p/n MSSF-024G-00
7.
Install Reflash Update CD 3/05 in the MUT-III laptop. Follow the CD installation instructions.
8.
Transfer the reprogramming data from the laptop to the memory card.
9.
Remove the memory card from the laptop and install it in the VCI. Connect the VCI to the vehicle.
YOU MUST DISCONNECT THE MUT-III LAPTOP.
10.
Reprogram the PCM, using automatic reprogramming. For reprogramming details, refer to TSB-03-00-015.
It will take up to 20 minutes to complete the reprogramming.
NOTE:
If the message "ECU at Current Level of VCI" appears, the PCM did not reprogram. Verify that the ROM ID is the same as the ROM ID listed
in the table shown.
If the ROM ID is the same as or higher than the ROM ID in the table, the PCM has been reprogrammed for this concern.
