Endeavor V6-3.8L SOHC (2004)
10.ALL AFFECTED VEHICLES: The following information will display after reprogramming. Note this information. Verify that the new
Hardware P/N (CANflash vehicles) or PCM Part No. (K-Line flash vehicles), and the Software P/N (CAN-flash vehicles) or ROM ID (K-Line flash
vehicles) are the same as those listed.
11.Turn the ignition switch to OFF. Disconnect the MUT-III from the vehicle. Wait at least 10 seconds, then start the engine to verify proper
operation.
12.Using a ball-point pen, enter the appropriate PCM part number, vendor number, ROM ID, this TSB number (TSB-05-13-010), your dealer code,
and the current date on the Engine Compartment and Control Module Label (part no. MSSF-024G-00).
