Endeavor V6-3.8L SOHC (2004)
Spark Plug: Testing and Inspection
SPARK PLUG TEST
1. Remove the spark plug and connect to the ignition coil.
2. Ground the spark plug outer electrode (body), and crank the engine.
Check that there is an electrical discharge between the electrodes at this time.
SPARK PLUG CHECK AND CLEANING
CAUTION:
-
Do not attempt to adjust the gap of the iridium plug.
-
Cleaning of the iridium plug may result in damage to the iridium tips. Therefore, if carbon deposits must be removed, use a plug cleaner and
complete cleaning within 20 seconds to protect the electrode. Do not use a wire brush.
Check the plug gap and replace if the limit is exceeded.
Standard value: 0.7 - 0.8 mm (0.028 - 0.031 inch)
Limit: 1.2 mm (0.047 inch)