Endeavor V6-3.8L SOHC (2004)
Use special tool MB990803 to remove the steering wheel.
[[E]] CLOCK SPRING REMOVAL
WARNING: The removed clock spring should be stored in a clean, dry place.
[[F]] AIR BAG MODULE REMOVAL (FRONT PASSENGER'S SIDE)
WARNING:
-
When the passenger's air bag module is removed, do not damage the engagement of the pawls.
-
The removed passenger's air bag module should be stored in a clean, dry place with the deployment surface facing up.
INSTALLATION SERVICE POINTS
]]A[[ PRE-INSTALLATION INSPECTION
WARNING: Dispose of air bag modules only according to the specified procedure. (Refer to Air Bag Module And Seat Belt Pre-tensioner
Disposal Procedures).
1. When installing the new air bag modules and clock spring, refer to "INSPECTION".
2. Connect the negative (-) battery cable.
CAUTION: To prevent damage to scan tool MB991958, always turn the ignition switch to the "LOCK" (OFF) position before connecting or
disconnecting scan tool MB991958.
3. Connect scan tool MB991958 to the data link connector.
4. Turn the ignition switch to the "ON" position.
5. Check DTCs using scan tool MB991958 to ensure entire SRS operates properly.
At this time, check that no DTC except 21 and 24 are set.
DANGER: Wait at least 60 seconds after disconnecting the battery cable before doing any further work. (Refer to SRS Service Precautions).
