Endeavor V6-3.8L SOHC (2004)
Air Bag: Testing and Inspection
AIR BAG MODULE CHECK
DANGER: Never attempt to measure the circuit resistance of the air bag modules (squib), even if you are using the specified tester. If the circuit
resistance is measured with a tester, accidental air bag deployment will result, and possible serious personal injury.
WARNING: If any component damage is found during the following inspection, replace the air bag module with a new one. Dispose of the old
one according to the specified procedure. (Refer to Air Bag Module And Seat Belt Pre-tensioner Disposal Procedures).
1. Check the pad cover for dents, cracks or deformation.
2. Check the connectors for damage, the terminals for deformation, and the harness for binding.
3. Check the air bag inflator case for dents, cracks or deformation.
4. Install the air bag module (driver's side) to the steering wheel and check fit and alignment with the steering wheel.
5. Install the air bag module (front passenger's side) to the instrument panel and front deck crossmember and check fit and alignment.
FRONT SEATBACK ASSEMBLY WITH SIDE-AIRBAG MODULE CHECK
