Endeavor V6-3.8L SOHC (2004)
Seat Belt: Service and Repair
Vehicles Without Advanced Air Bag
SEAT BELTS WITH PRE-TENSIONER
REMOVAL AND INSTALLATION <VEHICLES WITHOUT ADVANCED AIR BAG>
WARNING:
-
Never attempt to disassemble or repair the seat belt pre-tensioner. If faulty, replace it.
-
Be extremely careful when handling the seat with pre-tensioner. Do not subject it to shocks, drop it, bring it close to strong magnets or
allow contact with water, grease or oil. Always replace it with a new part if any dents, cracks or deformation is found.
-
Do not place anything on the seat belt pre-tensioner.
-
Do not expose the seat belt pre-tensioner to temperatures over 90 °C (194 °F).
-
After operating the seat belt pre-tensioner, replace the seat belt pre-tensioner with a new part.
-
Gloves and protective goggles must be worn when handling a seat belt pre-tensioner once it has been used.
-
If disposing of a seat belt with pre-tensioner which has not yet been operated, its seat belt pre-tensioner must be operated first before
disposal. (Refer to Air Bag Module And Seat Belt Pre-tensioner Disposal Procedures).
