Endeavor V6-3.8L SOHC (2004)
]]A[[ PRE-INSTALLATION INSPECTION
when installing the new front impact sensor, refer to "INSPECTION."
]]B[[ FRONT IMPACT SENSOR INSTALLATION
WARNING: The SRS may not activate properly if a front impact sensor is not installed properly, which could result in serious injury or death
to the vehicle's driver.
1. Securely connect the connector.
2. Position the front impact sensor facing toward the front of the vehicle as indicated by the arrow on the label, and install it securely.
]]C[[ POST-INSTALLATION INSPECTION
1. Reconnect the negative (-) battery cable.
2. Turn the ignition key to "ON" position.
3. Does the "SRS" warning light illuminate for approximately seven seconds, and then remain off for at least five seconds after turning "OFF"?
4. If yes, the SRS system is functioning properly.
If not, consult Supplemental Inflatable Restraint Lamp/Indicator/Testing and Inspection/Procedures.
