Endeavor V6-3.8L SOHC (2004)
Disconnect the negative (-) battery cable from the battery and tape the terminal to prevent accidental connection and air bag deployment.
INSTALLATION SERVICE POINTS
]]A[[ PRE-INSTALLATION INSPECTION
Check the seat slide sensor for dents, breakage and bending and measure the resistance between the terminals, even when installing a new seat slide
sensor.
]]B[[ SEAT SLIDE SENSOR INSTALLATION
WARNING: If the seat slide sensor is not installed securely and correctly, the driver's air bag may not operate normally.
Securely connect the connector.
]]C[[ POST-INSTALLATION INSPECTION
1. Reconnect the negative (-) battery cable.
2. Turn the ignition switch to the "ON" position.