Endeavor V6-3.8L SOHC (2004)
4. Remove the fuel level sensor (sub) mounting bolts and remove the fuel level sensor (sub) from service hole.
CAUTION: When inserting the fuel level sensor (sub) into the fuel tank, be careful not damage the sensor unit and the float.
5. Install the fuel level sensor (sub) to the fuel tank through the service hole.
6. Connect the fuel level sensor (sub) connector.
7. Install the service hole cover.
Tightening torque: 1.5 ± 0.5 Nm (14 ± 4 in-lb)
8. Install the floor mat into its original position.
9. Untie the right rear seat cushion, install it into its original position and tighten the mounting bolts to the specified torque.
Tightening torque: 44 ± 10 Nm (33 ± 7 ft-lb)
