Endeavor V6-3.8L SOHC (2004)
The crossmember mounting bolts need not be unscrewed when the front axle crossmember stay is replaced. However, the bolts may be loose while
the front axle crossmember stay is removed. It is recommended that you should retighten the bolts to 180 ± 20 Nm (13 ± 14 ft. lbs.).
<<D>> REAR ROLL STOPPER STEERING GEAR AND LINKAGE STABILIZER BAR AND FRONT AXLE NO.1 CROSSMEMBER
ASSEMBLY REMOVAL
Retain the front axle No. 1 crossmember with a transmission jack, and then remove the crossmember mounting bolt.
INSTALLATION SERVICE POINT
>>A<< STABILIZER BAR INSTALLATION
Align the stabilizer bar identification mark with the right end of the bushing (LH).
>>B<< POWER STEERING GEAR BRACKET INSTALLATION
Tighten the power steering gear bracket bolts in the alphabetical order shown.
>>C<< REAR ROLL STOPPER STEERING GEAR AND LINKAGE STABILIZER BAR AND FRONT AXLE NO.1 CROSSMEMBER
ASSEMBLY INSTALLATION
