Endeavor V6-3.8L SOHC (2004)
Align the stabilizer bar identification mark with the right end of the bushing (LH).
>>B<< FRONT AXLE NO.1 CROSSMEMBER REAR ROLL STOPPER AND STEERING GEAR ASSEMBLY INSTALLATION
Align the steering joint cover notch (arrow A) with the steering gear lug (arrow B), and install the front axle number 1 crossmember, the rear roll
stopper and steering gear assembly.
>>C<< FRONT AXLE CROSSMEMBER STAY/SELF-LOCKING NUT INSTALLATION
Ensure that the crossmember mounting bolts have been tightened to 160 - 200 Nm (119 - 147 ft. lbs.), and then install the front crossmember stay
with the self-locking nut.
INSPECTION
^
Check the stabilizer bushings for wear and deterioration.
^
Check the stabilizer bar for deterioration or damage.
^
Check all bolts for condition and straightness.
STABILIZER LINK BALL JOINT BREAKAWAY TORQUE CHECK
Required Special Tool:
^
MB990326: Preload Socket
