Endeavor V6-3.8L SOHC (2004)
Tire Pressure Sensor: Testing and Inspection
Tire Pressure Sensor ID Check
TIRE PRESSURE SENSOR ID CHECK
Required Special Tools:
^
MB991958: Scan Tool (MUT-III Sub Assembly)
^
MB991824: Vehicle Communication Interface (V.C.I.)
^
MB991827: MUT-III USB Cable
^
MB991910: MUT-III Main Harness A
Check the tire pressure sensor IDs, which is registered in the TPMS receiver, as described.
CAUTION: To prevent damage to scan tool MB991958, always turn the ignition switch to the "LOCK" (OFF) position before connecting or
disconnecting scan tool MB991958.
1. Connect scan tool MB991958 to the data link connector.
2. Turn the ignition switch to the "ON" position.
3. Select "Interactive Diagnosis" from the start-up screen.
4. Select "System select."
5. Choose "TPMS" from the "CHASSIS" tab.
6. Select "MITSUBISHI."
7. Select"Special Function."
8. Select "Tire Pressure Sensor ID Check."
9. Check the tire pressure sensor IDs on the PC display.
10. After tire pressure sensor ID check, turn the ignition switch to the "LOCK" (OFF) position.
11. Remove scan tool MB991958.
FROM SCAN TOOL MB99158 DIAGNOSIS SCREEN
You can check the tire pressure sensor ID on the diagnosis screen as described.
1. Operate scan tool MB991958 as follows:
^
Press "Special" button on the diagnosis screen.
^
Select"Tire Pressure Sensor ID Check" from the "Special Function" menu.
2. Check the tire pressure sensor IDs on the PC display.
3. After tire pressure sensor ID check, turn the ignition switch to the "LOCK" (OFF) position.
4. Remove scan tool MB991958.
