Endeavor V6-3.8L SOHC (2004)
Wheel Fastener: Service and Repair
Front Axle
HUB BOLT REPLACEMENT
Required Special Tools:
^
MB990767: End Yoke Holder
^
MB991618: Hub Bolt Remover
1. Remove the caliper assembly and suspend it with wire so that it does not fall.
2. Remove the brake disc.
3. Use special tool MB991618 to remove the hub bolts.
4. Install the plain washer to the new hub bolt, and install the bolt with a nut while holding the hub with special tool MB990767.
5. Install the brake disc, caliper assembly and tighten the caliper assembly mounting bolts to the specified torque 90 ± 10 Nm (67 ± 7 ft. lbs.).
