Endeavor V6-3.8L SOHC (2004)
POSITION OF THE PROP SHAFT. IT WILL DAMAGE THE OIL SEAL.
Install the new bolt only hand-tight, positioning the flat side of the new nut toward the center of the hub, and then tighten to 40 - 45 Nm (30 -
33 ft/lb). DO NOT OVERTORQUE.
Hold a wrench on the nut to prevent the prop shaft from rotating during tightening.
d.
Repeat Steps a. through c. for the other three bolts. Remove and replace the bolts one at a time.
e.
Retorque each bolt in the same order. Then mark each bolt with paint.
PARTS INFORMATION
Use the Genuine Mitsubishi Parts shown
WARRANTY INFORMATION