Endeavor V6-3.8L SOHC (2004)
Rear Door Window Glass: Adjustments
Glass Sliding Mechanism
GLASS SLIDING MECHANISM CHECK AND ADJUSTMENT
If the window glass automatically starts moving downwards at the wrong time while it is being raised, carry out the following adjustment or replacement
procedures.
1. Remove the door trim assembly.
2. Remove the waterproof film.
CAUTION: Insert a cushion or similar object to prevent damage to the glass if it should fall.
3. Remove the window regulator assembly from the door window glass, and then raise and lower the door window glass by hand to check the
operation force.
4. If the door window glass does not move up and down smoothly, check or repair the following points:
-
Check the installation condition of the run channel.
-
Repair any twisting in the door sash.
-
Check the installation condition of the lower sash.
NOTE: To align the lower sash, loosen the lower sash mounting bolts, and move the lower sash along the oblong mounting holes.
5. If repair or adjustment is not possible, replace the door assembly.