Endeavor 2WD V6-3.8L (6G75) (2008)
Engine Control Module: Removal and Replacement
POWERTRAIN CONTROL MODULE (PCM)
REMOVAL AND INSTALLATION
CAUTION:
-
Do not replace the PCM and the ETACS-ECU simultaneously. Always replace either one of the ECUs first, and register the encrypted
code (Refer to Chassis Electrical, Ignition Switch - Encrypted Code Registration Criteria Table). Then, replace the other ECU.
-
After the PCM is replaced, idling speed may be unstable because the MFI engine learning is not completed. To make it stable, make the
system learn the idling (Refer to General (Body and Chassis), Precautions before Service - Learning Procedure for Idling in MFI Engine).
Removal Steps 1-4