Endeavor 2WD V6-3.8L SOHC (2006)
1. Disconnect joint connector (4) C-101, and measure the voltage at the wiring harness side of joint connector (4) C-101.
2. Turn the ignition switch to the "ON" position.
3. Measure the voltage between joint connector (4) terminal 14 and body ground.
OK: 4.0 V or less
Q: Does the voltage measure 4.0 V or less?
YES: <The voltage measures 4.0 V or less> Go to Step 18.
NO: <The voltage measures more than 4.0 V> Go to Step 16.
STEP 16. Check SRS-ECU connector C-26 for loose, corroded or damaged terminals, or terminals pushed back in the connector.
CAUTION: The strand end of the twist wire should be within 10 cm (4 inches) from the connector.
Q: Is SRS-ECU connector C-26 in good condition?
YES: Go to Step 17.
NO: Repair the damaged parts.
STEP 17. Check the CAN_H line (communication line only) between joint connector (4) and SRS-ECU connector for a short to the power
supply. Measure the voltage at joint connector (4) C-101.
CAUTION: A digital multimeter should be used.
