Endeavor 2WD V6-3.8L SOHC (2006)
3. Measure the voltage between joint connector (4) terminal 3 and body ground.
OK: 1.0 V or less
CAUTION: Strictly observe the specified wiring harness repair procedure.
Q: Does the voltage measure 1.0 V or less?
YES: <The voltage measures 1.0 V or less> Diagnose CAN bus lines thoroughly by referring to DIAGNOSTIC ITEM 29: Diagnose CAN bus
lines thoroughly <Vehicles with ASC and vehicles without multi-center display (middle-grade type)>.
NO: <The voltage measures more than 1.0 V> Repair the wiring harness between joint connector (4) and the SRS-ECU connector.
STEP 45. Check the CAN_L line (communication line including the G and yaw rate sensor) between joint connector (4) and G and yaw rate
sensor connector for a short to the power supply. Measure the voltage at joint connector (4) C-101.
CAUTION: A digital multimeter should be used.
CAUTION: The test wiring harness should be used.
1. Disconnect joint connector (4) C-101, and measure the voltage at the wiring harness side of joint connector (4) C-101.
2. Turn the ignition switch to the "ON" position.
3. Measure the voltage between joint connector (4) terminal 1 and body ground.
OK: 4.0 V or less
