Endeavor 2WD V6-3.8L SOHC (2006)
YES: Go to Step 27.
NO: Repair the damaged parts. Replace the joint connector as necessary.
STEP 27. Check the CAN_L line (communication line including the combination meter) between joint connector (4) and the combination meter
connector for short to ground. Measure the resistance at joint connector (4) C-101.
CAUTION: A digital multimeter should be used.
CAUTION: The test wiring harness should be used.
1. Disconnect joint connector (4) C-101, and measure the resistance at the wiring harness side of joint connector (4) C-101.
2. Turn the ignition switch to the "LOCK" (OFF) position.
CAUTION: Disconnect the negative battery terminal.
3. Disconnect the negative battery terminal.
4. Measure the resistance between joint connector (4) terminal 4 and body ground.
OK: 1 kOhm or more
Q: Does the resistance measure 1 kOhm or more?
YES: <The resistance measures 1 kOhm or more> Go to Step 29.
NO: <The resistance measures less than 1 kOhm> Go to Step 28.
STEP 28. Check the CAN_L line (communication line only) between joint connector (4) and the combination meter connector for short to
ground. Measure the resistance at joint connector (4) C-101.
CAUTION: A digital multimeter should be used.
CAUTION: The test wiring harness should be used.
