Endeavor 2WD V6-3.8L SOHC (2006)
Q: Is SRS-ECU connector C-26 in good condition?
YES: Go to Step 17.
NO: Repair the damaged parts.
STEP 17. Check the CAN_H line (communication line only) between joint connector (4) and SRS-ECU connector for short to ground. Measure
the resistance at joint connector (4) C-101.
CAUTION: A digital multimeter should be used.
CAUTION: The test wiring harness should be used.
1. Disconnect joint connector (4) C-101 and SRS-ECU connector C-26, and measure the resistance at the wiring harness side of joint connector (4)
C-101.
2. Turn the ignition switch to the "LOCK" (OFF) position.
CAUTION: Disconnect the negative battery terminal.
3. Disconnect the negative battery terminal.
4. Measure the resistance between joint connector (4) terminal 14 and body ground.
OK: 1 kOhm or more
CAUTION: Strictly observe the specified wiring harness repair procedure.