Endeavor 2WD V6-3.8L SOHC (2006)
Q: Does the resistance measure 1 kOhm or more?
YES: <The resistance measures 1 kOhm or more> Go to Step 26.
NO: <The resistance measures less than 1 kOhm> Repair the wiring harness between joint connector (4) and the data link connector.
STEP 26. Check the CAN_L and H lines (communication lines only) between joint connector (4) and the intermediate connector for short
circuit. Measure the resistance at joint connector (4) C-101.
CAUTION: A digital multimeter should be used.
CAUTION: The test wiring harness should be used.
1. Disconnect intermediate connector C-31 and joint connector (4) C-101, and measure the resistance at the wiring harness side of joint connector (4)
C-101.
2. Turn the ignition switch to the "LOCK" (OFF) position.
CAUTION: Disconnect the negative battery terminal.
3. Disconnect the negative battery terminal.
4. Measure the resistance between joint connector (4) terminals 9 and 20.
OK: 1 kOhm or more
CAUTION: Strictly observe the specified wiring harness repair procedure.
Q: Does the resistance measure 1 kOhm or more?
