Endeavor 2WD V6-3.8L SOHC (2006)
1. Disconnect intermediate connector C-31 and joint connector (4) C-101, and measure the resistance at the wiring harness side of joint connector (4)
C-101.
2. Turn the ignition switch to the "LOCK" (OFF) position.
CAUTION: Disconnect the negative battery terminal.
3. Disconnect the negative battery terminal.
4. Measure the resistance between joint connector (4) terminals 9 and 20.
OK: 1 kOhm or more
CAUTION: Strictly observe the specified wiring harness repair procedure.
Q: Does the resistance measure 1 kOhm or more?
YES: <The resistance measures 1 kOhm or more> Diagnose CAN bus lines thoroughly by referring to DIAGNOSTIC ITEM 29: Diagnose CAN
bus lines thoroughly <Vehicles with ASC and vehicles without multi-center display (middle-grade type)>.
NO: <The resistance measures less than 1 kOhm> Repair the wiring harness between intermediate connector C-31 and joint connector (4).
