Endeavor 2WD V6-3.8L SOHC (2006)
5. Measure the resistance between joint connector (4) terminal 19 and middle-grade multi-center display connector terminal 13.
OK: 2 Ohms or less
CAUTION: Strictly observe the specified wiring harness repair procedure.
Q: Do all the resistances measure 2 Ohms or less?
YES: <All the resistances measure 2 Ohms or less> Power supply to the multi-center display (middle-grade type) may be suspected. Diagnose the
multi-center display (middle-grade type). Refer to Instrument Cluster/Carrier/Diagnosis By Symptom.
NO: <If either of the resistances measures more than 2 Ohms or all the resistances measure more than 2 Ohms> Repair the wiring harness
between joint connector (4) and the multi-center display unit (middle-grade type) connector.
STEP 20. Check the CAN bus lines between joint connector (4) and the data link connector. Measure the resistance between joint connector (4)
C-101 and data link connector C-121.
CAUTION: A digital multimeter should be used.
CAUTION: The test wiring harness should be used.
