Endeavor 2WD V6-3.8L SOHC (2006)
Steering Angle Sensor: Testing and Inspection
Steering Wheel Sensor Removal and Installation
STEERING WHEEL SENSOR
REMOVAL AND INSTALLATION
WARNING: Before removing the steering wheel and air bag module assembly, refer to Service Precautions and Air Bag Module and Clock
Spring.
CAUTION: Always carry out steering wheel sensor calibration after the steering wheel sensor has been installed. This is necessary because the
TCL/ASC-ECU should update the steering neutral point.
INSTALLATION SERVICE POINT
>>A<< STEERING WHEEL SENSOR NEUTRAL POINT ALIGNMENT
WARNING: Ensure that the clock spring's mating marks are properly aligned. If not, the steering wheel may not rotate completely
during a turn, or the flat cable in the clock spring could be damaged, This would prevent normal SRS operation and possibly cause
serious injury to the driver.
1. Align the mating marks of the clock spring. <Mating Mark Alignment>
1. Turn the clock spring clockwise fully. Then turn it back approximately 3-3/4 turns counterclockwise to align the mating marks.
2. Turn the front wheels to the straight-ahead position. Then install the clock spring to the column switch.
