mitsubishi Workshop Repair Guides

Mitsubishi Workshop Service and Repair Manuals

ABOUT US
Installation and Removal of Adhesive Components|Page 349 > < Trunk / Liftgate Striker|Adjustments

Endeavor AWD V6-3.8L (6G75) (2011)

  • Body and Frame
  • Exterior Moulding / Trim
  • System Information
  • Service and Repair
  • Installation and Removal of Adhesive Components

Page 1
background image

Exterior Moulding / Trim: Service and Repair
Installation and Removal of Adhesive  Components

INSTALLATION AND REMOVAL OF ADHESIVE COMPONENTS

MOLDING

ADHESIVE TAPE POSITION

REMOVAL

SIDE PROTECTOR MOLDING REMOVAL

Gently lift and remove the side protector molding. If there is any double-sided tape remaining on the side protector molding, remove according to the
following instructions.

Remove double-sided tape remaining on the body surface

  • Body and Frame
  • Exterior Moulding / Trim
  • System Information
  • Service and Repair
  • Installation and Removal of Adhesive Components

Installation and Removal of Adhesive Components|Page 349 > < Trunk / Liftgate Striker|Adjustments