Endeavor AWD V6-3.8L (6G75) (2011)
Heat Shield: All Technical Service Bulletins
Exhaust System - Heat Shield Rattling Noises
No: TSB-11-15-001
DATE: March, 2011
MODEL: See below
SUBJECT:
FRONT EXHAUST PIPE HEATSHIELD NOISE
This bulletin supercedes TSB-07-15-002REV, issued June, 2007, to expand the affected model years, add repair instructions and add part availability
information. It is a complete rewrite and individual changes are not shown.
PURPOSE
Customers of some affected may notice a rattle noise created by loose or corroded front exhaust pipe heat shields. This TSB advises the availability of
heat shields as spare parts preventing the need to replace the front exhaust pipe.
AFFECTED VEHICLES
2004 - 2011 Galant
2004 - 2011 Endeavor
2006 - 2012 Eclipse
2007 - 2012 Eclipse Spyder
PROCEDURE
Do not replace a front exhaust pipe to repair a heat shield rattle or other noise. Replace or remove only the affected heat shield(s) according to the
following instructions.
Refer to TSB-11-15-002 for heat shield replacement procedures
For Galant and Eclipse/Eclipse Spyder equipped with 2.4L engines built before December 4 2006:
NOTE:
When performing repairs on the front exhaust pipe of these vehicles, replace the front exhaust hanger with the new heat, resistant part indicated below.
CAUTION:
WEAR SAFETY GLASSES WHEN PERFORMING THESE REPAIRS.
1. Remove the heat shields and clamps from Front Exhaust Pipe 1.
2. Remove 3 heat shields from Front Exhaust Pipe 2 as follows:
^ Both rear heat shields and rear clamp.
^ The bottom front heat shield.
^ Retain the top front heat shield and secure it with 2 remaining clamps.
3. Replace the front exhaust hanger with a new heat resistant part.
NOTE: