Expo AWD L4-2350cc 2.4L SOHC 16 Valve (1993)
Refrigerant-Temperature Switch Removal
(From 1995 models)
(1) Remove the fitting block of the compressor.
(2) Remove the snap ring from inside the fitting block, and then remove the refrigerant-temperature switch.
Nut Removal
Bearing Removal
(1) Use a pointed tool such as an awl to remove the bearing cover and retainer.
(2) Insert the arms (3) of the special tool into the bearing groove at regular intervals.
(3) Turn the arms 90 to secure the arms to the bearing.
(4) Set the 3 arms installed to the bearing into the notches (3 places) located on the hanger of the special tool.
(5) Lower the base of the special tool to cover the hanger, and tighten the top nut until it touches the base.