Expo AWD L4-2350cc 2.4L SOHC 16 Valve (1993)
5. After disconnecting the battery cable, wait 60 seconds or more before proceeding with the following work. The SRS system is designed to retain
enough voltage to deploy the air bag for a short time even after the battery has been disconnected, so serious injury may result from unintended air
bag deployment if work is done on the SRS system immediately after the battery cable is disconnected.
6. SRS components should not be subjected to heat over 93C (200F), so remove the SRS air bag control unit, air bag module and clock spring before
drying or baking the vehicle after painting.
7. Whenever you finish servicing the SRS, check the SRS warning light operation to make sure that the system functions properly.
8. Make certain that the ignition switch is at OFF when the Scan Tool is connected or disconnected.
WARNING: SERIOUS INJURY CAN RESULT FROM UNINTENDED AIR BAG DEPLOYMENT SO USE ONLY THE
PROCEDURES AND EQUIPMENT SPECIFIED IN THIS MANUAL.
