Expo AWD L4-2350cc 2.4L SOHC 16 Valve (1993)
Fig. 2 Servicing Hub, Knuckle & Bearing
Replace hub, knuckle and bearing in numbered sequence shown in Fig. 1 and 2, noting following:
1. Remove caliper and suspend with wire, then remove driveshaft nut using end yoke holder, tool No. MB990767-01, or equivalent.
2. Disconnect ball joint and tie rod end using steering linkage puller, tool No. MB990635-01, or equivalent. Loosen but do not remove ball joint
and tie rod end nuts until knuckle is ready to be removed.
3. Using a suitable axle shaft puller, press driveshaft from front hub.
Fig. 3 Driveshaft Nut & Washer Installation
4. Ensure driveshaft nut and washer are installed in direction shown in Fig. 3.
