Expo AWD L4-2350cc 2.4L SOHC 8 Valve (1992)
A OIL PAN REMOVAL
1. Remove the all oil pan bolts.
2. Drive in the service tool between the cylinder block and oil pan.
NOTE: Never use a screwdriver or chisel, instead of the service tool, as a deformed oil pan flange will result in oil leakage.
B FLANGE NUT REMOVAL (ENGINE WITH COUNTERBALANCE SHAFTS)
1. Remove the plug on the side of the cylinder block.
2. Insert a Phillips screwdriver [shank diameter 8 mm (.32 in.)] into the plug hole to lock the counterbalance shaft.
3. Loosen the oil pump sprocket flange nut.
C PLUG REMOVAL
1. If the plug is too tight, hit the plug head with a hammer two to three times, and the plug will be easily loosened.
D FLANGE BOLT REMOVAL (ENGINE WITH COUNTERBALANCE SHAFTS)
1. Referring to B (2), lock the counterbalance shaft.
2. Loosen the flange bolt.
