Expo AWD L4-2350cc 2.4L SOHC 8 Valve (1992)
2. Avoid an overtightening.
G SEALANT APPLICATION TO OIL PRESSURE SWITCH
1. Coat the threads of the oil pressure switch with sealant and install the switch using the special tool.
Specified sealant: 3M ATD Part No.8660 or equivalent
CAUTION:
1. Keep the end of threaded portion clear of sealant.
2. Avoid an overtightening.
H RIGHT COUNTERBALANCE SHAFT REAR BEARING INSTALLATION (ENGINE WITH COUNTERBALANCE SHAFTS)
1. Apply engine oil to the outer surface of the bearing.
2. Using special tools, install the right rear bearing. Make sure that the oil hole of the bearing is aligned with the oil hole of the cylinder block.
I
LEFT COUNTERBALANCE SHAFT REAR BEARING INSTALLATION (ENGINE WITH COUNTERBALANCE SHAFTS)
1. Install the special tool (Guide Plate) to the cylinder block.