Expo LRV AWD L4-1834cc 1.8L SOHC 16 Valve (1992)
Fig. 2 Ignition Timing Connector Identification
4. With the engine stopped, remove the waterproof female connector from the ignition timing adjustment terminal, located in the engine
compartment. Ground the terminal using a lead wire with alligator clips (Fig. 2).
5. Start and run the engine at idle. Check the basic idle speed.
Basic Idle Adjustment Screw
7. If idle speed is not within specification, adjust by turning the Speed Adjusting Screw (SAS).
7. If idle speed cannot be adjusted within specification by turning the Speed Adjusting Screw (SAS), inspect the fixed Speed Adjusting Screw (fixed
SAS).
8. Stop the engine. Disconnect the lead wire from the ignition timing adjustment connector and remove the tachometer and the paper clip.
9. Start and run the engine at idle.
CAUTION: The Fixed SAS should not be adjusted. Precise adjustments and setting were performed by the manufacturer. If the adjustment has been
altered, readjust as follows.
