FE120 L4-4.9L DSL Turbo (2005)
Removal: Case
-
Loosen the water separator sensor and drain fuel from the case.
Installation: Case
-
Clean the O-ring mounting surface of the fuel filter head.
-
Replace the filter element and O-ring with new one.
-
Apply a thin coat of engine oil to the O-ring, and install it on the case and water separator sensor.
CAUTION:
-
Be sure to use only genuine MITSUBISHI filter elements. The use of non-genuine fuel filters can cause engine failure.
-
Prevent fine dust particles from entering the fuel filter and fuel pipe, as they can cause problems such as faulty fuel injection.