FE120 L4-4.9L DSL Turbo (2005)
[Inspection]
-
Apply 5 V DC to terminals 4 and 2 of the accelerator pedal position sensor.
-
Measure the output voltage at terminals 2 and 5 (sensor 1) and the output voltage at terminals 1 and 2 (sensor 2) with the accelerator lever in each
specified position.
A: Position In which accelerator lever is touching stopper
B: Position at which continuity between terminals 2 and 3 disappears as accelerator pedal is pushed downward
C: Position in which accelerator lever is touching stopper bolt
-
If any output voltage is out of specification, make an adjustment.
-
If any output voltage is still out of specification when you have made an adjustment, replace the sensor.
