FE639 L4-39L DSL Turbo (1998) High Idle Switch (Location)
[4] Installation of idling control cable
-
Rotate idling control knob 1 counterclockwise until the inner cable protrudes at its maximum.
-
While maintaining this state, install accelerator arm assembly *1.
[7] Accelerator control cable
[Installation]
-
Mount accelerator control cable 7 to accelerator arm assembly *1.
-
Make sure that the accelerator pedal does not move by turning idling control knob 1 clockwise as far as it will go.
-
Mount the engine end of accelerator control cable 7 to control lever A of injection pump assembly *3.
-
Tighten the accelerator control cable 7 using adjustor nut B so that the accelerator pedal does not move.
NOTE: When mounting accelerator control cable 7, do not move control lever A.
[Adjustment]
-
Turn the starter switch ON, and press down on the accelerator pedal until control lever A hits stopper bolt C.
