FE639 L4-3.9L DSL Turbo (1998)
[16] Inspection of boost temperature sensor
-
Place boost temperature sensor 16 in glycerin in a container.
-
Raise the glycerin temperature to the specified values and stir the glycerin.
-
Measure the resistance between terminals 1 and 2.
-
If the measured value deviates from the standard value, replace boost temperature sensor.
[17] Inspection of emergency engine stop handle
-
Push emergency engine stop handle 17 all the way.
-
In this step, make sure that stop lever A of the governor is in contact with stopper bolt B.
-
If the stop lever does not contact the stopper bolt, turn nut C until they contact, and tighten nut D to secure it in place.
-
Inner wire E of stop cable F should be taut. If not, make adjustment.
CAUTION: Be careful not to make the tension of inner wire E too high, since excess tension prevents stop lever A from fully
