mitsubishi Workshop Repair Guides

Mitsubishi Workshop Service and Repair Manuals

Removal and Replacement|Page 420 > < Fuel Filter|Specifications|Page 417
Page 1
background image

Fuel Filter: Removal and Replacement

Replacing Fuel Filter

Service procedure

[3] Fuel filter

WARNING:
-

Fuel ignites easily. Do not get it near flame or heat.

-

Wipe up any spilled gas oil because it can cause a fire.

[Removal]

[Installation]

WARNING:  You must use a genuine replacement part filter because using unsuitable fuel filter 3 can cause fuel leakage and a fire.

-

Install by tightening by three-quarters to one full turn after contact surface A of fuel filter head 5 contacts gasket B of fuel filter 3. Be sure to
tighten by hand.

-

After installation, run the engine to check for fuel leakage.

Cleaning Gauze Filter

Cleaning Gauze Filter

-

Remove the eyebolt 1 from the suction port side A of the fuel feed pump.

-

Remove the gauze filter 2 from the eyebolt 1. Clean the gauze filter 2 in diesel fuel.

-

Refit the gauze filter 2 and eyebolt 1 in the opposite order to that in which they were removed.

-

Bleed all air out of the fuel system.

-

Start the engine and check that no fuel leakage occurs.

Removal and Replacement|Page 420 > < Fuel Filter|Specifications|Page 417