Galant L4-1997cc 2.0L SOHC 16 Valve (1993)
Continuity: ........................................................................................................................................................................................... Should exist
8. Using an Ohm meter check for continuity between relay harness connector 3 and ground.
Continuity: ...................................................................................................................................................................................... Should not exist
9. With the ECM and the relay connected, measure Voltage at terminal 2 of the relay.
-
While cranking the engine Voltage should be 8 Volts or more.
-
With the engine running at over 2,000 rpm Voltage should be near battery Voltage.
If any of the previous tests produce unsatisfactory results, the harness will need to be repaired or replaced. Once repairs have been completed, road
test the vehicle to confirm that the repair has corrected the problem.
If the same problem reoccurs, it is possible that there is an intermittent failure of the component or the ECU. Check for looseness at all harness
junctions and test for an intermittent failure.